I just plugged a mp3 player into the mic in socket Nothing impossible, don’t worry. They’re nice folks who’ll get you sorted in no time and establish what the issue may be. It will be a much hotter signal than the one directly from your bass so start with the Input Level knob at a low setting and gradually turn it up if you decide to try that. There is no software control. Therefore, there can be confilcts.
|Date Added:||5 October 2013|
|File Size:||58.45 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
At software level, you may downmix this sound to mono, but this degrades quality because of the muted channel with noise.
By pressing ‘print’ button you will print only current page. Was calewalk an input level problem as Chappel suspected? To play sound, you need audio system rights.
Just compile the driver with “make” and install it with “make install”. ON Advanced mode This mode uses the dedicated driver. The same rules apply here. You may not export or reexport, directly or indirectly, the Cakewalk Product into any xakewalk prohibited by the United States Export Administration Act and the regulations thereunder.
[ubuntu] Cakewalk UA-1G Soundcard in Advanced Mode?
A brief interval a few seconds after connecting the USB cable is required before the unit will operate normally. If you could hear the sample data, the UA-1G is correctly connected adfanced your computer and the driver has been installed correctly.
Using my system anyway The settings look fine. Chappel Max Output Level: Bookmarks Bookmarks Digg del. These various purposes may require different software.
Unplug the USB cord, plug it again. You should be able to play music.
Thanks in advance for your reply. Index Index Numerics Installing the driver Macintosh Record the digital stream using the following command: And thanx for your reply!
You may not decompile, reverse engineer, disassemble, or otherwise reduce the Cakewalk Software to a human-perceivable form.
Removing The Driver Troubleshooting Removing the driver Your computer may fail to correctly recognize the UA-1G if the driver addvanced not be installed according to the specified procedure. If you do not agree to these terms, do not download the material.
Hardware Drivers & Downloads
There are very tiny little switches recessed on the back of the UA-1G. Just make sure you read the instructions and ensure that all the switches on the back are set correctly and that you select ‘Advanced Drive mode’ on the interface.
Page 36 Page 37 – Recording digital audio from your comput Full support for bit playback and recording at rates up to 96 kHz has been successfully tested. It will color the tone because the signal has been processed by your amp’s preamp.
Enter text from picture: Important Notes Do not use this device in the vicinity of such contents of data that was stored on a storage device receivers. We recommend using the alphanumeric name of the device. It records at the rate of either Page 30 Driver installation and settings Did you hear the sample data? Device or resource busy You can play sounds at higher sample rates and bit precision using Advanced mode. Alternatively you can do it manually like this:.