MS 7518 VER 1.0 DRIVER

To connect the ATX pin power supply, make sure the plug of the power pin 13 supply is inserted in the proper orientation and the pins are aligned. All cautions and warnings on the equipment should be noted. Correc t CP U placement 4. Please do not fold the Serial ATA cable into degree angle. Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. Make sure the safety hook completely clasps the fixed bolt of the retention mechanism.

Uploader: Mikree
Date Added: 20 November 2012
File Size: 11.2 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 34977
Price: Free* [*Free Regsitration Required]

ATX 12V power connection should be greater than 18A. Replace only with the same or equivalent type recommended by the manufacturer. Fasten down the lever. Lower the CPU down onto the socket.

MSI BIOS for MSI Motherboards MS

Position the cooling set onto the retention mechanism. Fer hile doing the installation, be careful in holding the components and follow the installation procedures. Microsoft is a registered trademark of Microsoft Corporation. Moreover, PCI Express architecture provides a high performance graphics infrastructure for Desktop Platforms doubling the capability of existing AGP8x designs with transfer rates of 4.

Operation is subject to the following two conditions: The gold arrow should point as shown in the picture. Hardware Setup Hardware Setup This chapter tells you how to install the CPU, memory modules, and expansion cards, as well as how to setup the jumpers on the mainboard. Meanwhile, read the documentation for the expansion card to make any necessary hardware or software settings for the expansion 5718, such as jumpers, switches or BIOS mw.


Align the retention mechanism and the backplate.

MSI Ms-7518 P6ngm2 Motherboard SKT 775 Ddr2 NVIDIA Mcp73pv

Turn over the mainboard again, and plac e the mainboard on the f lat surface. Please turn off the power and unplug the power cord before installing the CPU. Always read the safety instructions carefully.

The plastic clip at each side of the DIMM slot will automatically close. The module will only fit in the right orientation. It’s a community-based project which helps to repair anything. Open Lever Sliding Plate 90 degree 2. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications.

The appearance of your ve may vary depending on the model you purchase.

MSI MS Instruction manual |

If you do not have the heat sink and cooling fan, contact your dealer to purchase and install them before turning on the computer. We do not guarantee the damages or risks caused by inadequate operation or beyond product specifications. However, please cer sure your components are able to tolerate such abnormal setting, while doing overclocking.


Otherwise, the Line-Out connector on the back panel will not function. Power supply of watts and above fer highly recommended for system stability. If any of the following situations arises, get the equipment checked by a service personnel: To clear CMOS you should: These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.

Before inserting the power supply connector, always make sure that all components are installed properly to ensure that no damage will be caused. However, memory modules of the same type and density are required while using dual-channel DDR, or instability may happen.

JLPC1 The pin header is for internal debugging only. These two connectors connect to the ATX power supply and have to work together to ensure stable operation of the mainboard.

While disconnecting the Safety Hook from the fixed bolt, it is necessary to keep an eye on your fingers, because once the Safety Hook is disconnected from the fixed bolt, the fixed lever will spring back instantly. Then push down the power supply firmly into the connector. Look for the gold arrow on the CPU.